continue 20 ! Continues to apply rules normally only
! applied to prefix-list 2. To apply to
! prefix-list 1, too.
! Any attributes set in '20' will
! override any set during '10'.
route-map RED permit 20
match ip address prefix-list 2
set ip next hop 10.2.2.2 ! Last rule overrides previous rules from
! previous '10' rule-set.
\end{cisco}
When rules from a rule-set is chained together as shown above. The last rule will override all previous set values regarding the attribute being applied. In this case \texttt{next-hop} from 'permit 10' is overridden in 'permit 20'.
\subsection[States]{BGP States}
The states is the way \gls{bgp} handles peer/neighbor connection establishing. The \underline{playbook} so to speak.
\begin{enumerate}
\item Idle: \gls{bgp} while initializing refuses all incoming connections. Will initiate \gls{tcp} connection to peer.
\item Connect: Waits for \gls{tcp} connection. If \gls{tcp} is established goes to state OpenSent. If \gls{tcp} is \textit{un}successful ConnectRetry timer is started and then goes to Active state.
\item Active: When ConnectRetry counter reaches 0 goes to state Connect.
\item OpenSent: Sends \gls{msg} to remote node. Waits for reply \gls{msg} before going to OpenConfirm.
\item OpenConfirm: Nodes exchange keepalive \glspl{msg} and goes to Established state if successful.
\item Established: Nodes can now exchange KeepAlive, Updates, and Notification \glspl{msg}.
\gls{ibgp} is running \gls{bgp} within the same \gls{as} between routers. Much like running a general \gls{igrp} in the network.
Tradition one has to be fearful of creating \textit{routing loops} in the network. \glspl{bgp} mechanism for this is using either \begin{mylist}\item Full Mesh, or \item\glspl{rr}\end{mylist}.
Problems by running \textit{Full Mesh} is the formula of \[ iBGPsessions = n*(n-1)/2\]\note{where $ n $ is the number \gls{ibgp} speakers} which results in scaling problems as \gls{ibgp} speakers are added to the \gls{as}.
\textit{\glspl{rr}} solves this problem by peering with all \gls{ibgp} speakers in the \gls{as}. All \gls{ibgp} speakers are then clients of the \glspl{rr}. This in turn helps maintainability by also advertising routes learnt from \gls{ibgp} clients to clients. Classic filtering/mathing route-maps/prefix-filters can be used to \textit{not} advertise all routes select group of clients from the \glspl{rr}.
\item Next hop does \textit{not} change for \gls{ebgp} routes advertised to \gls{ibgp} neighbours \textit{by-default}\footnote{Often times it is necessary to tell a router to set itself as the next-hop before advertising to \gls{ibgp} neighbours}.
